PRESONUS TUBEPRE User Manual download pdf (Page 14)

With a compressor/EQ/dynamics processor

When running the Tube Pre in conjunction with other processors it is

recommended that the TubePRE be the first unit in the chain. The

other units should be connected to the output (either XLR or 1/4”) of

the TubePRE. Most compressors require that the signal be preamplified

before they are connected. This simply means that the signal is loud

enough for the compressor to process it. In most cases (and there are

exceptions) if you were to plug a microphone/guitar directly into a

compressor the signal will be too low (essentially too quiet) for the

device to process it.

On Recording

When using the TubePRE as a front end for a recording device (such as

the Presonus FIREstation), it is important to watch your output levels.

For example, using the TubePRE for distortion (turning up the gain and

tube drive REAL HIGH) could overload the inputs of the recording

device. In this scenario it is necessary to limit the output level of the

TubePRE. This can be accomplished by using a compressor/limiter

(such as the Presonus BlueMAX).

3.6 FAQ/Troubleshooting

Can I switch the tube?

The TubePRE’s tube can be switched as long as it is a 12AX7. Proper

caution must be taken when switching the tube. Please refer to Section

3.5 of this manual for further directions on changing the tube or check

our website at www.presonus.com.

1 2 ... 9 10 11 12 13 14 15 16 17 18

No comments

PRESONUS TUBEPRE User Manual Page 14