Presonus AudioBox 44VSL User Manual Page 28

  • Download
  • Add to my manuals
  • Print
  • Page
    / 84
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 27
24
PreSonus AudioBox
22/44VSL
Overview Hookup Connecting
to a
Computer
Software: Virtual StudioLive
SL Remote,
and Studio One Artist
Tutorials Technical
Information
Troubleshooting
and Warranty
4 Software: Virtual StudioLive and Studio One Artist
Software: Virtual StudioLive
and Studio One Artist
24
High Pass Filter Freq Adjust the High Pass Filter’s Cutoff Frequency.
The High Pass filters cutoff frequency can be set from 18 Hz to 1.3 kHz.
Remember that all frequencies below a high-pass filter’s cutoff
frequency are attenuated. See Section 5.3.1 for more details.
The slope of the High Pass filter is -6 dB/octave.
The High Pass Filter is accessible from the Main VSL Page as well as the
Gate Zoom.
Power User Tip: A high-pass filter attenuates all frequencies
below the set threshold. Use this filter, instead of an equalizer, to
remove unwanted low frequencies from your source signal.
Gate On/Off Button Turns the Gate On and Off for the Selected Channel or Bus.
This button engages and disengages the gate for the selected channel. It
will illuminate to indicate that the gate has been enabled.
The gate is available for all input and output buses.
Gate Threshold Sets the Threshold of the Gate for the Selected Channel or Bus.
The Gate Threshold determines the level at which the gate will open.
Essentially, all signals above the threshold setting are passed through
unaffected. You can set the threshold from 0 to -84 dB.
The Gate can be controlled either via the
Threshold knob or from the Gate Graph.
Compressor On/Off Turns the Compressor On and Off for the Selected Channel or Bus.
This button engages or disengages the compressor for the selected
channel or output bus. It will illuminate to indicate that the compressor
has been enabled.
The compressor is available for all input and output buses.
Auto Mode Button Enables Automatic Response Mode.
When Auto mode is active, the Attack and Release controls become
inoperative, and a preprogrammed attack and release curve is used. In
this mode, the attack is set to 10 ms, and the release is set to 150 ms. All
other compressor parameters can still be adjusted manually.
4.1 Virtual Studio Live
Page view 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 83 84

Comments to this Manuals

No comments