Presonus AudioBox 44VSL User Manual download pdf (Page 33)

Owner’s Manual

OverviewHookupConnecting

to a

Computer

TutorialsTechnical

Information

Troubleshooting

and Warranty

Software: Virtual StudioLive

SL Remote,

and Studio One Artist

Software: Virtual StudioLive and Studio One Artist 4

Software: Virtual StudioLive

and Studio One Artist

Loading an FX Preset

To load an FX preset, select it from the Browser window, and drag it over

any part of the desired FX bus in the Master section of the Overview tab.

Once the preset is loaded, you can use the FX Type menu to change the

eﬀect and create new presets.

4.1.6 Using VSL to Create a Monitor Mix

Virtual StudioLive allows you create a monitor mix with the same sound

quality and ﬂexibility you’d get from a StudioLive 16.0.2 digital mixer. By

adding Fat Channel dynamics processing and EQ, reverbs, and delays

to your monitor mix, you can enhance the quality of the performer’s

recording experience and, by extension, the quality of their performance.

A monitor mix is a dedicated mix that is usually routed to a performer’s

headphones. This mix is separate from the mix that is recorded.

It allows you, as the engineer, to leave your recording mix intact,

while providing the artist with the mix that they need to achieve

their best performance, saving hours of retakes and frustration.

STEP 1 Creating a Mix for the Main and Headphone Outputs

Using VSL to create a mix for your Main and Headphone outputs is like

using a mixer. Raise the fader for each channel to raise its volume in the

mix and use the pan control to adjust the source signal’s position in the

stereo ﬁeld. To adjust the overall mix level, raise or lower the Main fader in

VSL or use the Main and Phones knobs on the front of your AudioBox

22/44VSL.

Power User Tip: Raising a channel’s volume is not always the best way to make

it louder in the mix. By adjusting the pan position or adding some EQ, you can

raise the perceived loudness of the channel without touching the fader.

STEP 2 Creating a Mix for Outputs 3 and 4 (AudioBox 44VSL Only)

The AudioBox 44VSL also allows you to create a separate mix for Outputs

3 and 4. This done by using channel sends that enable you to set the levels

for each channel that is routed to a speciﬁc output bus—in this case,

Output 3 or Output 4. For any given channel, you can create one mix for

your Main, Headphone, and Line 1 and 2 outputs and create an entirely

mix for Outputs 3 and 4.

It is important to mention that Outputs 3 and 4 are

stereo-linked, so you will have one send level for each

channel to both Outputs 3 and 4 simultaneously.

The Output 3 send slider sets the level for each channel,

while the Output 4 send slider is the pan control for

each channel that’s routed to Outputs 3 and 4.

Virtual Studio Live 4.1

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 83 84

Comments to this Manuals

No comments

Presonus AudioBox 44VSL User Manual Page 33

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Presonus AudioBox 44VSL